FPUDVS2008A_FPUDVS2009A_FPUDVS2010A_FPUDVS2011A_FPUDVS2012A蠕动泵OMEGA欧米茄

cfpudvs2000a系列将接受三种不同类型的外部输入信号中的任*何***种：4至20 mA、0至10 Vdc或频率。4至20 mA和0至10 Vdc回路必须通电。可接受两种类型的频率输入，交流正弦波（磁线圈类型输出）和数字方波（霍尔效应信号、触点闭合）。电路板上的跳线插头在出厂时为交流正弦波信号预设，使用数字方波信号时必须重新定位跳线。所有接线都应在位于FPUDVS2000A系列侧面的接线盒内进行。提供了***个液体密封接头，应用于外部信号电缆。信号输入线按所用信号类型进行颜色编码。

 FPUDVS2008A_FPUDVS2009A_FPUDVS2010A_FPUDVS2011A_FPUDVS2012A蠕动泵OMEGA欧米茄

最大工作压力：100磅/平方英寸/6.9巴（大多数型号）

最高流体温度：54°C（130°F）

环境温度范围：-10至43°C（14至110°F）

外壳：NEMA 3R（IP24）（室内使用可接受）

泵管材料：Norprene?

工作循环：连续

最大固体：体积的50%

最大粘度：5000厘泊

最大吸力：高达9 m（30’）的水

调低比例：20:1

功率要求：115伏60赫兹80瓦，220伏50赫兹40瓦，230伏60赫兹45瓦

变速：115伏60赫兹40瓦，220伏50赫兹40瓦，230伏60赫兹40瓦

尺寸：155.6高x 257.2宽x 228.6毫米深（6_x 10_x 9英寸）

变速：159 H x 254 W x 235 mm D（6?x 10 x 9?“）

重量：3.6千克（8磅）

管接头：压缩倒钩式（内直径×外直径）

 FPUDVS2008A_FPUDVS2009A_FPUDVS2010A_FPUDVS2011A_FPUDVS2012A蠕动泵OMEGA欧米茄

Peristaltic Pump Tube Does Not Require Valves

Self Priming

High Outlet Pressure Capability of 100 psig on Most Models

Improved Pump Head Design

Corrosion Proof Polybutylene Terephthalate Housing

Tamper Resistant Electronic Control Panel Cover

Tube Failure Detection

Fixed-Timer Control

The FPU2000A Series fixed pumps feed by an analog fixed 60 second timer. The pump can be on for 1 to 60 seconds. All FPU2000A Series have fixed speed outputs and can be adjusted by selecting the pumphead tube size and choosing the desired RPM (revolutions per minute).

Standard Percentage & Digital Percentage Controllers

The FPUVS2000A and FPUDVS2000A Series variable speed pumps are for continuous pumping relatively pulse free, even while adjusting the percentage of output. The variable speed pump requires the use of brushes on the DC motor. Excellent brush life expectancy (2000 hours). An extra set of brushes included with every pump. 

The FPUDVS2000A Series will accept any one of three different types of external input signals; 4 to 20 mA, 0 to 10 Vdc, or frequency. The 4 to 20 mA and 0 to 10 Vdc loops must be powered. Two types of frequency inputs, AC sine waves (magnetic coils type outputs) and digital square waves (Hall Effect signals, contact closures), are acceptable. A jumper plug located on the circuit board is factory pre-set for AC sine wave signals, the jumper must be re-positioned when digital square wave signals are being used. All wiring connections are to be made inside of the junction box located on the side of the FPUDVS2000A Series. A liquid tight connector is supplied and should be used for the external signal cable. The signal input wires are color coded to the type of signal being used.

SPECIFICATIONS

Maximum Working Pressure: 100 psig/6.9 bar (most models)

Maximum Fluid Temperature: 54°C (130°F)

Ambient Temperature Range: -10 to 43°C (14 to 110°F)

Enclosure: NEMA 3R (IP24) (acceptable for indoor use)

Pump Tube Material: Norprene?

Duty Cycle: Continuous

Maximum Solids: 50% by volume

Maximum Viscosity: 5000 Centipoise

Maximum Suction Lift: Up to 9 m (30') water

Turn Down Ratio: 20:1

Power Requirements: 115 V 60 Hz 80 Watts, 220 V 50 Hz 40 Watts, 230 V 60 Hz 45 Watts

Variable Speed: 115 V 60 Hz 40 Watts, 220 V 50 Hz 40 Watts, 230 V 60 Hz 40 Watts

Dimensions: 155.6 H x 257.2 W x 228.6 mm D (6? x 10? x 9")

Variable Speed: 159 H x 254 W x 235 mm D (6? x 10 x 9?")

Weight: 3.6 kg (8 lb)

Tube Connection: Compression barb type (?” ID x ?" OD)