FMXD11_FPUD411_FPUD421_FMXD11-AM管状混合器OMEGA欧米茄

混合管和电机采用模块化结构单独提供，以实现***大的灵活性。

TEFC电动或气动型号

与非涡流、非充气作用混合

fmxd11搅拌机可以有效地从55加仑桶的顶部到底部混合，而无需拆除桶盖。可选的IPS鼓塞适配器允许将搅拌机固定安装到鼓上。搅拌机通过直径为2“的混合管每分钟抽取约14加仑液体（***大粘度750 cp，***大密度1.8 s.g.）。流体温度范围为0至93°C（32至200°F）。

FMXD11_FPUD411_FPUD421_FMXD11-AM管状混合器OMEGA欧米茄

混合管内的轴装式涡轮以3450转/分（空气马达从300转/分到3000转/分）的转速旋转，在四个上部进气口处产生稳定的吸气效果。液体通过管被强制向下，并通过管底部的端口强制排出，分解和溶解沉降颗粒（最大固体尺寸为1/8”）。fmxd11搅拌机具有非涡流、非充气作用。

混合管长度不到1 m（38”）。他们有聚四氟乙烯轴承在管的中心和基础，以及石墨填充聚四氟乙烯密封。轴、涡轮、混合管和套筒均为316不锈钢。混音器可配备气动或电动马达。

气动?HP电机在3.4至6.2巴（50至90磅/平方英寸）的压力下以10至15 cfm的空气运行，包括流量调节器和消声器。

TEFC电动1/4 HP电机具有热过载保护功能，配有一个开/关开关和一根3.6 m（12’）三线电缆，带插头（不带插头提供FPUD421）。

FMXD11_FPUD411_FPUD421_FMXD11-AM管状混合器OMEGA欧米茄

Mixing Tubes and Motors Supplied Separately in Modular Construction for Maximum Flexibility

TEFC Electric, or Air Driven Models Available

Mix With a Non-Vortexing, Non-Aerating Action

FMXD11 mixers efficiently mix from the top of a 55-gallon drum to the bottom, without requiring removal of the drum lid. The optional IPS drum bung adaptor allows fixed mounting of the mixer to the drum. Mixers draw approximately 14 gallons of liquid (750 cp max viscosity, 1.8 S.G. max density) per minute through the 2" diameter mixing tube. Fluid temperature range is 0 to 93°C (32 to 200°F).

A shaft-mounted turbine inside the mixing tube rotates at 3450 RPM (from 300 to 3000 RPM for the air motor), creating a steady suction effect at the four upper intake ports. Liquid is forced down through the tube and forcefully expelled through the ports at the bottom of the tube, breaking up and dissolving settled particles (maximum solid size is 1?8"). FMXD11 mixers work with a non-vortexing, non-aerating action.

The mixing tubes are just under 1 m (38") long. They have PTFE bearings at the center and base of the tube, and a graphite-filled PTFE seal. The shaft, turbine, mixing tube, and sleeve are 316 stainless steel. Mixers are available with either an air-driven or electric motor.

The air-driven ? HP motor operates with 10 to 15 CFM air at 3.4 to 6.2 bar (50 to 90 psig), and includes a flow regulator and muffler.

The TEFC electric ? HP motors are thermaloverload protected, and come with an on/off switch and a 3.6 m (12') three-wire cord with plug (FPUD421 supplied without plug).