SCR-210A015U01_SCR-210A012U01_SCR-210A014U01_SCR19Z-M功率控制器OMEGA欧米茄

SCR19系列SCR功率控制器仅用于将电力与电阻负载（如烤箱、熔炉、热封器等）进行比例分配（注：它们不用于驱动变压器或任何感应负载）。

SCR19系列控制器提供两种比例控制方法-零电压切换和相位角点火。在零电压切换模式下，控制器打开交流电源电压的完整循环。触发电路设计为尽可能接近交流正弦波穿过零点的点打开SCR。实际上，线路电压是开着和关着的，并在整个循环中施加到加热器上。

SCR-210A015U01_SCR-210A012U01_SCR-210A014U01_SCR19Z-M功率控制器OMEGA欧米茄

The SCR19 Series SCR Power Controllers are designed to proportion electric power to resistive loads only, such as ovens, furnaces, heat sealers, etc. (NOTE: They are not designed to drive transformers or any inductive load.) 

These heater controllers consist of power semi-conductors (SCRs), properly-sized heat sinks, trigger circuitry, and fuses supplied on panels for surface mounting. The SCR power controller accepts a 4 to 20 mA dc output from a temperature controller or can be supplied with manual option using a remote potentiometer. 

The SCR19 Series controllers offers two methods of proportional control – Zero-voltage-switched and Phase-angled-fired. With the Zero-voltage-switching mode, the controller switches on complete cycles of the ac supply voltage. The trigger circuit is designed to turn on the SCRs as close as possible to the point where the AC sine wave crosses through zero. In effect, the line voltage is turned on and off and applied to the heaters in whole cycles. 

SCR-210A015U01_SCR-210A012U01_SCR-210A014U01_SCR19Z-M功率控制器OMEGA欧米茄

SCR19系列控制器提供两种比例控制方法-零电压切换和相位角点火。在零电压切换模式下，控制器打开交流电源电压的完整循环。触发电路设计为尽可能接近交流正弦波穿过零点的点打开SCR。实际上，线路电压是开着和关着的，并在整个循环中施加到加热器上。

当输入为4至20 mA时，Heter控制器的输出将在4 mA以下关闭，在20 mA时完全打开。比例作用是通过改变循环次数来实现的。输出将从低输入时的***个循环打开和九个循环关闭到***大输入时的所有循环打开。

SCR19可控硅功率控制器的输出由加热器集成，加热器产生与输入信号直接变化的平滑比例热输出。在相位角点火模式下，通过控制全交流正弦波每半个周期的开启（点火）点来控制负载功率。