FLDW3302ST_FLDW3303ST_FLDW3304G_FLDW3305ST_FLDW3306G转子流量计OMEGA

直读式空气、水、N2、H2、 CO2、Ar、He和O2转子流量计

计量管带有导流条或导流槽，有助于提供可靠、准确的读数

正面防护罩中的放大透镜可增强读数分辨率

流量管与浮子具备互换性

流量管的安装与更换非常方便

简便的面板安装方式

FLD系列转子流量计是***种精密仪器，专门用来直接读取流量，它们体现了经典转子流量计所固有的简洁、通用及经济实惠特点。它非常适合计量色层分离法中应用的载体气体、指示和控制加工过程中的气体，还非常适合实验室及实验工厂中气体的测量以及流量和液位指示等。在装配完整发货时，这些流量计中包括标准安装接头（有多种材质备选）、侧面板、较厚的正面放大防护罩和背板，还包括内置的控制阀和流量管。使用选配的丙烯酸三角架FLTR-1，可将面板安装方式转变成支架安装方式。这种三角架中自带水平仪和调平螺钉。 

FLDW3302ST_FLDW3303ST_FLDW3304G_FLDW3305ST_FLDW3306G转子流量计OMEGA

Flowmeters are equipped with built-in 6-ring needle valves, 16-ring high-precision metering valves with "non-ascending stem", or may not be equipped with any valves. As long as high sensitivity control and high resolution are required, especially when used in conjunction with metering tubes for measuring very low flow rate, high-cost high-resolution valves are worth the money. Generally speaking, when measuring gas, it is recommended to install the valve at the entrance (bottom); when measuring liquid, the valve can be installed at both the entrance and the exit (top). For vacuum applications, valves must be installed at the outlet. If not specified at the time of ordering, the valve will be installed at the inlet of the flowmeter at the time of shipment.

FLDW3302ST_FLDW3303ST_FLDW3304G_FLDW3305ST_FLDW3306G转子流量计OMEGA

Standard Accuracy: Full Range (+5%)

Repeatability: +0.25%

Available Flow Range: Minimum 10:1

Maximum working pressure: 200 psig/13.8 bars

Maximum operating temperature: 121 C (250 F)

Texture of material

Flow tube: thick-walled borosilicate glass

Float: glass, sapphire, 316 stainless steel, tungsten cobalt carbide and tantalum contact with liquid installation joint selection: black anodic alumina or 316 stainless steel

Side panel: black anodic alumina

Frontal shield: polycarbonate resin with lenses for lengthwise magnification to enhance reading resolution

Back: 1_8"Thick White Acrylic Resin

O-rings and fillers: Sodium butadiene rubber O-rings are used in aluminium/copper flowmeters. Fluorine Rubber O-Ring Used in Stainless Steel Flowmeter

Selection: Perfluororubber and EPR

Connection Port: 1_8 NPT Internal Thread Inlet and Outlet Connection Port